I just got a set of ramps and they help a lot. Mine fold and will fit in my tool box bit they can always stick out if needed just make sure they are tied down.
answered 1 year, 2 months ago
You do have to completely take the unit off to load and off load your ATV. I agree that is a little inconvenient but for my uses I think it works perfectly. I only load and unload during one trip if I have to haul it a shot distance I simply don't use it...
answered 1 year, 6 months ago
I pull the coupler tube out. then I have another device which is merely a round JACK POST welded to a small piece of 2" square tube in the middle, this inserts in the coupler tube hole and then i use 2" x8" scaffold planks with 2 muffler clamps attached at one end, bottom side,they slide on from either side and your ramps cant kick out!!! works very well, and the guard dog stays in your hitch.
answered 2 years, 8 months ago
By turning the vertical stem it is adjustable up or down with the set screw. Detach from your bike, lower stem, unload bike, close tailgate (optional), raise stem . tighten set screw, and drive off with unit still attached.
answered 2 years, 9 months ago
I contacted the manufacturer they stated to unload, all you have to do is take the pin out of the upright tube and loosen the slip handle. Unlatch the trailer coupler where it attaches to the machine and pull the upright assembly out of the base. You can leave the tube in the truck hitch and the tube coupler in most cases.
answered 3 years, 7 months ago
- springfield, mo