Looking for Answers about Bass Pro Shops Bass Pro Shops® Outboard Boat Motor Support Bracket?

The Bass Pro Shops® Outboard Boat Motor Support Bracket will support a 8 horsepower motor.

yes, i use it on a 60hp Mercury, if you have manual trim, make sure your bungy cord is extra tight to stop the motor from bouncing around..

Yes, with no poblem.

yes, should fit perfectly. I have a 25 and it fit. I think this is designed for smaller outboards. I had to move it around for the best fit.

The rubber lets the motor move from side to side. no good!!!!

you can't, buy a new replacement unit.

Bass Pro Shops or their catologue.

Yes, this Bass Pro Shops® Outboard Boat Motor Support Bracket will support 125 horsepower motor.

Yes, it will support the outboard engine with ease.

since with a pontoon it is about support not clearance like a regular boat trailer..

couple options for you, just cut a new piece of square tubing to the lenght you need to make it long and stiff use a heavier tubing, also if you don't go far and often, due what most due since the pontoon trailer are so high off the ground, put the motor all the way down, turn it all the way one way and use a rachet strap from the traler around the motor back to the trailer, all your trying to due is stop the motor from bouncing up and down and putting strain on the transom of the boat, just make sure your lower unit is still at least 18" or more off the ground and you are good to go.... done this hauling the potoon 120 miles each way twice every year......work great...

Support brackets can cost from 40 dollars to over a hundred. I find the Bass Pro Shop support bracket works very well and it cost about 40 dollars.